Preliminary NJM2747Single Supply Quad Operational Amplifier with Full Swing Output ■GENERAL DESCRIPTION The NJM2747 is a quad low supply voltage operational amplifier with Full swing output. It is suitable for audio section of portable sets, PCs and any General-purpose use. ■ FEATURES ●Operating Voltage :2.5V to 14V ●Output Full Swing : VOH ≥4.9V Typ. (at V+=5V, RL=5kΩ) : VOL ≤0.1V Typ. (at V+=5V, RL=5kΩ) ●Offset Voltage :1mV Typ ●Slew Rate : 3.5V/µs Typ. . ●Low Distortion : 0.001% typ. (at V+=5V, f=1kHz) . ●Low Input Voltage Noise :10nV/√Hz typ. ●Bipolar Technology ●Package Outline : DIP14, DMP14, SSOP14 ■ PIN CONFIGURATION 123456714■PACKAGE OUTLINE NJM2747D NJM2747MNJM2747V - ++ -13121110- ++ -98PIN FUNCTION1. A OUTPUT 2. A -INPUT 3. A +INPUT +4. V 5. B +INPUT 6. B –INPUT 7. B OUTPUT 8. C OUTPUT 9. C -INPUT 10. A +INPUT 11. GND 12. D +INPUT13. D –INPUT14. D OUTPUT NJM2747D NJM2747M NJM2747V (Top View) Ver.2004-11-26 -1- NJM2747 Preliminary■ ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL Supply Voltage Differential Input Voltage Range Common Mode Input Voltage Range Power Dissipation Operating Temperature Range Storage Temperature Range +RATINGS UNIT V V V V 15 VID ±15 (Note1) VICM 0 to 15 (Note1) DIP14 (870) DMP14 (450) (Note2) DMP14 (560) (Note3) SSOP14 (420) (Note2) SSOP14 (520) (Note3) -40 to +85 -50 to +125 PD Topr Tstg mW ˚C ˚C (Note1) For supply voltage less than 15V, the absolute maximum input voltage is equal to the supply voltage. (Note2) On the PCB “ EIA/JEDEC (76.2×114.3×1.6mm, two layers, FR-4) “ (Note3) On the PCB “ EIA/JEDEC (76.2×114.3×1.6mm, four layers, FR-4) “ ■ OPERATING VOLTAGE (Ta=25˚C) PARAMETER SYMBOL RATINGS Supply Voltage V +UNIT V 2.5 to 14 ■ ELECTRICAL CHARACTERISTICS ●DC CHARACTERISTICS (V+=5V,Ta=25˚C) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT Operating Current Input Offset Voltage Input Bias Current Input Offset Current Large Signal Voltage Gain Common Mode Rejection Ratio Supply Voltage Rejection Ratio Output Voltage Input Common Mode Voltage Range ICC RL=∞, VIN=2.5V, No Signal Apply - 8 11 mA VIO RS ≤ 10kΩ - 1 6 mV IB - 100 350 nA IIO - 5 100 nA AV RL≥10kΩ to 2.5V, 65 85 - dB Vo=0.5V to 4.5V CMR SVR VOH VOL 0V ≤ VCM ≤ 4V +V=2.5V to 14V RL=5kΩ to 2.5V RL=5kΩ to 2.5V 60 60 4.75 - 0 75 80 4.9 0.1 - - - - 0.25 4 dB dB V V V VICM CMR ≥ 60dB ●AC CHARACTERISTICS (V+=5V,Ta=25˚C) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT Unity Gain Bandwidth Phase Margin Equivalent Input Noise Voltage Total Harmonic Distortion Amp to Amp Separation GB ΦM VNI THD CS f=10kHz RL=10kΩ, CL=10pF f=1kHz, VCM=2.5V f=1kHz, AV=+2 RL=10kΩ to 2.5V, Vo=1.5Vrms f=1kHz RL=10kΩ to 2.5V, Vo=1.5Vrms - 10 - MHz - 75 - Deg - 10 - nV/√Hz- 0.001 - % - 120 - dB ●AC CHARACTERISTICS (V+=5V,Ta=25˚C) PARAMETER SYMBOL TEST CONDITION MIN. TYP. MAX. UNIT Slew Rate SR (Note 4), AV=1, VIN=2Vpp RL=10kΩ to 2.5V CL=10pF to 2.5V - 3.5 - V/µs (Note 4) Number specified is the slower of the positive and negative slew rates. - 2 - Ver.2004-11-26 Preliminary NJM2747 ■ MEMO [CAUTION] The specifications on this data book are only given for information, without any guarantee as regards either mistakes or omissions. Theapplication circuits in this data book are described only to show representative usages of the product and not intended for theguarantee or permission of any right including the industrial rights. Ver.2004-11-26 -3-